TREK-510 ARM-based, In-Vehicle Computing Box

The TREK-510 is a dedicated box computer for industrial vehicle fleets, transport trucks, buses and taxis. TREK-510 combined with a variety of I/O connectors can be connected to devices like OBD-II or TPMS (Tire Pressure Monitoring System). Built-in wireless communications-WWAN enable TREK-510 to send important driver/vehicle/location/car information back to the control center. TREK-510 can also operate in extreme environments with features like a wide working temperature range (-30 to 70 degrees) and anti-shock/vibration design. TREK-510 also uses a special design to handle the critical issue of in-vehicle power. Special power protection (ISO7637-2/SAE J1455 Class A/ SAE J1113) and car power management software (Ignition on/off, delay on/off, low battery monitor) prevent electrical noise and surges from impacting the system, guarding against damage from transient car power.

Features
Specs
Datasheet

ST ARM based STA2062 333 MHz CPU with Win CE
Automotive grade working temperature range (-30 to 70° C)
Rich I/O such as CAN, multi-COMs, isolation 4DI/4DO, line out, Mic in, USB, SD
Built-in RF communication modules, such as GPRS/HSDPA/CDMA
Certifications: CE, FCC, E-mark and MIL-STD-810G, ISO7637-2, SAE J1113, SAE J1455 regulations
Ignition on/off delay; SW detectable/controllable for car power management
Built in G sensor for active security system

System

Soc: STM industrial degree STA2062 ARM9-based 333 Mhz RISC SOC
System Memory: Mobile DDR 128 MB
Watchdog: Yes
RTC: Yes, with one time 200 mAh coin battery
Operating System: Win CE 5.0 English core version as default

Physical

Dimensions: 261 x 125 x 59.1 mm
Weight: 1.5 kg

Storage

On Board Flash: 2 GB on board flash for bootloader, image & Customer's AP
SD slot: 1 x (external accessible)

Display Interface

Smart Display Port: Design compatible with TREK-303L, 7" smart display, the signal includes: - 18-bit LVDS out - 1 x RS-232 - 1 x audio line out - 1 x USB Host - 12 V @ 1 A output

I/O

CAN: 1 x CAN 2.0 A/B by DB9 with J1939 protocal
USB Host: 1 x USB 2.0 host port by type A
USB Client: 1 x USB Client by Mini Type AB
Mic: In 1 x RCA jack
Line-out: 1 x RCA jack
COM: Port COM 1&2: 2 x Full Function RS-232, 5 V/12 V @ 0.5 A, ping9, by jumper selection
COM3: 1 x 4-wire RS-232/485 (controlled by software), 5 V/12 V @ 0.5 A, ping9, by jumper selection
Isolation: DI/DO 4 x Isolated dry contact digital inputs from DB9 connector (2500 Vrms protection) 4 x relay driver from DB9 connector

Communication

WWAN: GPRS - Cinterion MC55i: Support GPRS class 10 (Quad-band) CDMA - Sierra Wireless MC 5728V: Support EV-DO REV A, EV-DO,CDMA (1900 MHz, 800 MHz) HSDPA - Sierra Wireless MC 8790V: Support EDGE, GPRS, GSM, HSDPA, HSUPA (GPRS/EDGE class B, multislot class 12) (Quad-band)

GPS

RF Receiver Type: 32 Channels (built-in), GPS L1 frequency, C/A code
Cold Start: 39 s
Warm Start: 33 s
Hot Start: < 1 s
AGPS: 3 s
Acquisition: -145dBm m
Protocol: NMEA Input/output, ASCII, 0183, 2.3 (compatible to 3.0)
Antenna: SMA connector for external antenna
RF Receiver Type: 50 channels, GPS L1 frequency (option)
Cold Start: 29 s
Warm Start: 29 s
Hot Start: < 1 s
AGPS: 5 s
Acquisition: -160dBm
Protocol: NMEA Input/output, ASCII, 0183, 2.3 (compatible to 3.0)
Antenna: SMA connector for external antenna

LED

LED indicator Power (Red), GPS operation (Blue), WWAN link (Green), Status (Green)

Datasheet for TREK-510 ARM-based, In-Vehicle Computing Box

	Datasheet - Brief details and specifications on TREK-510 ARM-based, In-Vehicle Computing Box

TREK-510 ARM-based, In-Vehicle Computing Box (TREK-510)

Datasheet for TREK-510 ARM-based, In-Vehicle Computing Box